上海闊志閥門有限公司安裝2W水用黃銅、不銹鋼電磁閥10個要求

1、水用電磁閥的工作介質應清潔無顆粒雜質，電磁閥內件表面上的污物及過濾器，需定期清潔干凈。

2、在電磁閥發生故障時，為了及時隔離電磁閥，并保證系統正常運行，安裝旁路裝置。

3、安裝時電磁閥線圈向上，并保持垂直位置，電磁閥上箭頭或標記應與管道流向*，不得安裝在有濺水或漏水的地方。

4、在管路系統中，安裝在支路上的電磁閥通徑應小于主管道閥門的通徑。

5、安裝電磁閥前，管道必須清洗干凈。建議在閥前安裝過濾器，蒸汽管道安裝疏水閥。

6、不能將閥安裝在管道的低凹處，以免因蒸汽冷凝水、雜質等沉淀在閥內而防礙動作。

7、不能在爆炸危險場合使用。

8、在管路剛性不足情況下，建議把閥前管道用支架固定，以免電磁閥工作時引起振動。

9、在安裝前，要注意看清產品標牌，認真閱讀使用說明書，判斷產品是否符合使用條件。

2W water with brass, stainless steel solenoid valve works, 2W water brass, stainless steel solenoid valve in a sealed chamber, at different locations with holes, each hole leads to a different pipeline, the middle chamber is valve, both sides are two electromagnets, which the magnet coil is energized the body surface to which side will be attracted to different file live or leaked oil discharge hole by controlling the movement of the valve body, and into the hole is always open The hydraulic oil will enter a different outlet pipe, 2W water with brass, stainless steel solenoid valve and then through the pressure oil to drive oil just the piston, the piston and drive the piston rod drive mechanism moving. Thus by controlling the solenoid current is controlled mechanical movement